|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
MATERIAL SAFETY DATA SHEETHILTI, INC.
PRODUCT NAME: CA 3400 Heavy-Duty Subfloor Adhesive DESCRIPTION: Vinyl Laquer Adhesive INGREDIENTS AND EXPOSURE LIMITS
PEL = OSHA Permissible Exposure Limit. TLV = ACGIH Threshold Limit Value. These are 8 hour time-weighted averages unless otherwise indicated by "C" (Ceiling) or "STEL" (Short Term Exposure Limit). NE = None Established. NA = Not Applicable. PHYSICAL DATA
FIRE AND EXPLOSION HAZARD DATAFLAMMABLE LIMITS: Lower 1.2%; Upper = 12.8% FLASH POINT: < 0° F. (Setaflash) EXTINGUISHING MEDIA: CO2, Dry Chemical, Foam, Water SPECIAL FIRE FIGHTING PROCEDURES: Soak packaging with water spray. A self-contained breathing apparatus should be worn when fighting fires involving chemical products. UNUSUAL FIRE AND EXPLOSION HAZARDS: Thermal decomposition and combustion products can be formed. See below. Isolate from heat, electrical equipment, sparks, and open flames. REACTIVITY DATASTABILITY: Stable. INCOMPATIBILITY: Material does not mix or dilute well with water. HAZARDOUS DECOMPOSITION PRODUCTS: Thermal decomposition can yield CO, CO2. HAZARDOUS POLYMERIZATION: Will not occur. CONDITIONS TO AVOID: Excessive heat and ignition sources such as flames or sparks. Storage above 100° F. Exposure to moisture. HEALTH HAZARD DATAKNOWN HAZARDS: Acute: Eye and skin irritation. Central nervous system (CNS) depressant.. Chronic: Prolonged and repeated inhalation of vapors including intentional abuse can lead to damage to the brain and nervous system.. SIGNS AND SYMPTOMS OF EXPOSURE: Eye, skin and respiratory irritation. Can have an anesthetic effect if inhaled. Headache, dizziness, staggering, confusion, unconsciousness or coma can occur from repeated or intentional inhalation of a high concentration of vapors. CARCINOGENICITY: IARC classifies crystalline silica as a Gp IIA carcinogen based upon inhalation of respirable dust. This product does not pose a dust hazard; therefore, this classification is not applicable. PRIMARY ROUTES OF EXPOSURE: Dermal. Inhalation MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: Eye, skin, and respiratory conditions. EMERGENCY AND FIRST AID PROCEDURESEYES: Immediately flush with plenty of water. Call a physician. SKIN: Wash with soap and water. Launder contaminated clothing before reuse. INHALATION: Move victim to fresh air. Give oxygen and/or artificial respiration if needed. Call a physician. INGESTION: Give plenty of water to drink. Never give anything by mouth to an unconscious person. Seek medical attention. Do not induce vomiting unless directed to by a physician. OTHER: Referral to a physician is recommended if there is any question about the seriousness of the injury/exposure. CONTROL MEASURES AND PERSONAL PROTECTIVE EQUIPMENTVENTILATION: Natural or mechanically induced fresh air movements are necessary to maintain vapor concentrations below recommended exposure and/or flammable limits. EYE PROTECTION: Not normally required, however, safety glasses should be worn in most industrial settings. SKIN PROTECTION: Gloves recommended (cotton gloves are adequate). RESPIRATORY PROTECTION: Not normally required when adequate ventilation is maintained as described above. Use a NIOSH-approved organic vapor respirator when vapor concentrations exceed recommended exposure limits. Never enter a confined space without an appropriate air-supplied respirator. PRECAUTIONS FOR SAFE HANDLING AND USEHANDLING AND STORING PRECAUTIONS: Extremely flammable. Keep away from ignition sources such as heat, sparks, and flame. Avoid contact with eyes, skin, and clothing. Use with adequate ventilation. Wash thoroughly after handling. SPILL PROCEDURES: Remove all sources of ignition. Scoop up and place in a container for proper disposal. Not soluble in water. Excess spillage can be removed by wiping with mineral spirits. REGULATORY INFORMATIONOSHA HAZARD COMMUNICATION: This MSDS has been prepared in accordance with the federal OSHA Hazard Communication Standard. HMIS CODES: Health 2, Flammability 3, Reactivity 0, PPE B DOT SHIPPING NAME: Adhesives, Class 3, UN 1133, Pkg. Gp. III. TSCA INVENTORY STATUS: Chemical components listed on TSCA inventory. SARA TITLE III, SECTION 313: This product contains 7% Toluene (CAS # 108-88-3) which is subject to reporting under Section 313 of the Superfund Amendments and Reauthorization Act of 1986 and 40 CFR Part 372. WASTE DISPOSAL METHODS: Consult with regulatory agencies or corporate personnel for disposal methods that comply with local, state, and federal health and environmental regulations. HEALTH / SAFETY CONTACTS: The information and recommendations contained herein are based upon data believed to be correct; however, no guarantee or warranty of any kind expressed or implied is made with respect to the information provided. |
[MAIN MENU] | [TABLE OF CONTENTS] | [SELECTOR GUIDE] |
[FIRESTOP PROGRAM] | [HAP PROGRAM] | [DECKING PROGRAM] |
[HILTI WEB SITE] | [SEARCH] | [SUBMITTAL PACKAGE] |
[Product Description] | [Product Approvals] | [Guide Specifications] | [Material Specifications] | [Technical Data] |
[Installation] | [Ordering] | [MSDS] | [Video] | [Product Data] |